Codigo Escuela 4.0
The aim of the retraction test is to achieve a "cleaner" part without material residues in the movement areas of the hotend. The slicer parameters that influence this test are mainly speed and retraction distance.
How to proceed
Download the retraction test part
We download the following part (Retraccion_Test) and adjust the printing parameters as follows:
- Temperature: The one obtained with the temperature tower test for the chosen material.
- Flow: The one obtained with the flow test.
- Layer height: 0.2 mm
- Initial shrinkage:
| Extrusion | Distance | Velocity | 3D printer |
| Short Bowden | 4 mm | 40 mm/s |
Ender 3 or similar |
| Long bowden | 4 mm | 40 mm/s |
CR10, Tevo Tornado or similar |
| Direct | 1 mm | 35 mm/s |
Prusa MK3s, Artillery X1 or similar |
Observe the finished part
With the finished, part we observe the amount of "hairs" that have been generated between the different shapes (next image). Next, we adjust the distance between the shapes:
- If there is fuzz between the shapes, we increase the value by 1mm.
- If there is no fuzz, we decrease the value by 0.5mm.
Printing the part again
We print the part again using the new shrinkage data and check. Next, we do this iteration several times until there is no link between the shapes of the part and the shrinkage values are as conservative as possible (the lower the better).
In the following example, after several iterations with a Prusa MK3S the following shrinkage parameters have been obtained: 35mm/s and 0.9mm with a temperature of 205 degrees and a nozzle of 0.4mm.
Latest posts
